Table of Contents
Advertisement
Ethernet Port Commands
hold-time
Syntax
hold-time time-value
no hold-time
Context
config>port>ethernet>efm-oam
Description
This command configures efm-oam operational transition dampening timers which reduce the number of
efm-oam state transitions reported to upper layers.
Default
0
Parameters
time-value — Indicates the number of seconds that the efm-oam protocol will wait before going back to the
operational state after leaving the operational state. Note that the hold-time does not apply if efm-oam
moved from operational to link-fault.
A hold-time value of zero indicates that there should be no delay in transitioning to the operational state.
A non-zero value will cause the efm-oam protocol to attempt to negotiate with a peer if possible, but it
will remain in the send-local-remote-ok state until the hold time has expired if negotiation is successful.
If efm-oam is administratively shutdown while it was in the operational state and then re-enabled when
a non-zero hold time is configured, efm-oam will attempt transition to the operational state
immediately.
Values
mode
Syntax
mode {active | passive}
Context
config>port>ethernet>efm-oam
Description
This command configures the mode of OAM operation for this Ethernet port. These two modes differ in that
active mode causes the port to continually send out efm-oam info PDUs while passive mode waits for the
peer to initiate the negotiation process. A passive mode port cannot initiate monitoring activites (such as
loopback) with the peer.
Default
active
Parameters
active — Provides capability to initiate negotiation and monitoring activities.
passive — Relies on peer to initiate negotiation and monitoring activities.
transmit-interval
Syntax
[no] transmit-interval interval [multiplier multiplier]
Context
config>port>ethernet>efm-oam
Description
This command configures the transmit interval of OAM PDUs.
Page 220
0 — 50
7710 SR OS Interface Configuration Guide
Advertisement
Table of Contents
