Alcatel-Lucent 7710 SR Configuration Manual page 418

Service router os interface configuration guide
Hide thumbs Also See for 7710 SR:
Table of Contents

Advertisement

Port Show Commands
SM-TTI Tx (<mode>)
SM-TTI Rx
FEC Corrected 0s
FEC Corrected 1s
FEC Uncorrectable
Sub-Rows
FEC SES
SM BIP8
SM BEI
SM SES
PM BIP8
PM BEI
PM SES
Sample Output
A:ALA-49>config>port# show port 3/2/1 otu detail
===============================================================================
OTU Interface
===============================================================================
OTU Status
Cfg Alarms
Alarm Status
SF/SD Method
Page 390
Label
This is the configured SM-TTI (Section Monitor Trail Trace Identifier)
to be transmitted by this port in the OTU overhead bytes. The modes
are auto, string, or bytes. In the auto and string modes, a printable char-
acter string will be displayed. In bytes mode, up to 64 hex bytes will be
displayed
This is the SM-TTI (Section Monitor Trail Trace Identifier received by
this port. When the received TTI is a printable string of characters, it
will be displayed as a text string. When the received TTI contains one
or more non-printable characters, it will be displayed at a sequence of
64 hex bytes. When the received TTI is all zeros, the string "Not Spec-
ified" will be displayed.
Displays the number of bits that were received as 0s but corrected to
1s.
Number of bits that were received as 1s but corrected to 0s.
The number of sub-rows that were not corrected because too many
errors were detected.
The number of severely errored seconds were the number of uncorrect-
able sub-rows was greater than 15% of the maximum.
The number of detected BIP-8 errors in the section monitor overhead.
The number of backward error indications received from the far end in
the section monitor overhead.
Section monitor severely errored seconds where the number of SM-
BIP8 was greater than 15% of the maximum.
The number of detected BIP-8 errors in the section monitor overhead.
The number of backward error indications received from the far end in
the section monitor overhead.
Section monitor severely errored seconds where the number of SM-
BIP8 was greater than 15% of the maximum.
: Enabled
: loc los lof lom otu-ber-sf otu-bdi fec-sf
:
: FEC
Description (Continued)
FEC Mode
Data Rate
SF Threshold
SD Threshold
7710 SR OS Interface Configuration Guide
: enhanced
: 11.049 Gb/s
: 1E-5
: 1E-7

Advertisement

Table of Contents
loading

Table of Contents