Table of Contents
Advertisement
802.1x Port Commands
quiet-period
Syntax
quiet-period seconds
no quiet-period
Context
config>port>ethernet>dot1x
Description
This command configures the period between two authentication sessions during which no EAPOL frames
are sent by the 7710 SR.
The no form of this command returns the value to the default.
Default
30
Parameters
seconds — Specifies the quiet period in seconds.
Values
radius-plcy
Syntax
radius-plcy name
no radius-plcy
Context
config>port>ethernet>dot1x
Description
This command configures the RADIUS policy to be used for 802.1x authentication. An 802.1x RADIUS
policy must be configured (under config>security>dot1x) before it can be associated to a port. If the
RADIUS policy-id does not exist, an error is returned. Only one 802.1x RADIUS policy can be associated
with a port at a time.
The no form of this command removes the RADIUS policy association.
Default
no radius-plcy
Parameters
name — Specifies an existing 802.1x RADIUS policy name.
re-auth-period
Syntax
re-auth-period seconds
no re-auth-period
Context
config>port>ethernet>dot1x
Description
This command configures the period after which re-authentication is performed. This value is only relevant
if re-authentication is enabled.
The no form of this command returns the value to the default.
Default
3600
Parameters
seconds — The re-authentication delay period in seconds.
Page 232
1 — 3600
7710 SR OS Interface Configuration Guide
Advertisement
Table of Contents
