Table of Contents
Advertisement
loopback
Syntax
loopback {line | internal | remote}
no loopback
Context
config>port>tdm>e3
config>port>tdm>ds3
Description
This command puts the specified port or channel into a loopback mode.
The corresponding port or channel must be in a shutdown state in order for the loopback mode to be enabled.
The upper level port or channel or parallel channels should not be affected by the loopback mode.
NOTE: This command is not saved in the router configuration between boots.
The no form of this command disables the specified type of loopback.
Default
no loopback
Parameters
line — Places the associated port or channel into a line loopback mode. A line loopback loops frames
received on the corresponding port or channels back to the remote router.
internal — Places the associated port or channel into a internal loopback mode. A internal loopback loops
the frames from the local router back at the framer.
remote — Sends a signal to the remote device to provide a line loopback.
mdl
Syntax
mdl {eic | lic | fic | unit | pfi | port | gen} mdl-string
no mdl
Context
config>port>tdm>ds3
Description
This command configures the maintenance data link (MDL) message for a DS-3/E-3.
This command is only applicable if the DS-3/E-3 is using C-bit framing (see the framing (DS3) command).
The no form of this command removes the MDL string association and stops the transmission of any IDs.
Default
no mdl
Parameters
mdl-string — specify an MDL message up to 38 characters long on a DS-3.
eic — Specifies the equipment ID code up to 10 characters long.
lic — Specifies the equipment ID code up to 11 characters long.
fic — Specifies the ID code up to 10 characters long.
unit — Specifies the unit ID code up to 6 characters long.
pfi — Specifies the facility ID code up to 38 characters long.
port — Specifies the port ID code up to 38 characters long.
gen — Specifies the generator number to send in the MDL test signal message up to 38 characters long.
7710 SR OS Interface Configuration Guide
Interface Configuration
Page 297
Advertisement
Table of Contents
