Table of Contents
Advertisement
member
Syntax
[no] member port-id
Context
config>port>multilink-bundle
Description
This command binds a channel group to a multilink bundle. For IMA and MLFR groups, this command
binds a channel group filling up the entire DS-1 or E-1. For MLPPP groups, fractional (n x ds0) DS1 or E1
links are also allowed. However, fractional DS1 links and fractional E1 links may not be combined in the
same multilink bundle. If a channel with a different number of timeslots than the primary-link member is
added to the bundle, a warning will be provided.
The no form of this command removes the specified channel group from the multilink bundle.
Default
None
Parameters
port-id — Specifies the physical port ID.
minimum-links
Syntax
minimum-links minimum-links
no minimum-links
Context
config>port>multilink-bundle
Description
This command sets the minimum number of links that must be active for the bundle to be active.
If the number of active links drops below the configured minimum then the multilink bundle will transition
to an operationally down state.
The no form of this command removes the minimum link limit.
Default
1
Parameters
minimum-link — Specify the minimum link limit, expressed as an integer.
Values
mlfr
Syntax
mlfr
Context
config>port>multilink-bundle
Description
This command enables the context to configure a Multi-link Frame Relay (MLFR) bundle.
7710 SR OS Interface Configuration Guide
Syntax: slot/mda/port.channel
1 — 8
Interface Configuration
Page 243
Advertisement
Table of Contents
