LAG Commands
propagate-topology-change
Syntax
propagate-topology-change
[no] interconnect
Context
config>eth-ring>propagate-topology-change
This command configures the G.8032 sub-ring to propagate topology changes. From the sub-ring to the
major ring as specified in the G.8032 interconnection flush logic. This command is only valid on the sub-
ring and on the interconnection node. Since this command is only valid on a Sub-ring, a virtual link or non-
virtual link must be specified for this command to be configured. The command is blocked on major rings
(when both path a and b are specified on a ring).
The no form of this command sets propagate to the default
Default
no propagate-topology-change
Page 310
7710 SR OS Interface Configuration Guide