Table of Contents
Advertisement
Ethernet Port Commands
qinq-etype
Syntax
qinq-etype 0x0600..0xffff
no qinq-etype
Context
config>port>ethernet
Description
This command configures the Ethertype used for Q-in-Q encapsulation.
The no form of this command reverts the qinq-etype value to the default.
Parameters
0x0600..0xffff — Specifies the qinq-etype to expect.
Values
report-alarm
Syntax
[no] report-alarm [signal-fail] [remote] [local] [no-frame-lock] [lcd]
Context
config>port>ethernet
Description
This command specifies when and if to generate alarms and alarm clear notifications for this port.
Parameters
signal-fail — Reports an Ethernet signal lost alarm.
remote — Reports remote faults.
local — Reports local faults.
no-frame-lock — Reports a 'not locked on the ethernet framing sequence' alarm.
lcd — Reports a codegroup delineation error.
speed
Syntax
speed {10 | 100 | 1000}
Context
config>port>ethernet
Description
This command configures the port speed of a Fast Ethernet port when autonegotiation is disabled. If the port
is configured to autonegotiate this parameter is ignored. Speed cannot be configured for ports that are part of
a Link Aggregation Group (LAG).
Default
100
Parameters
10 — Sets the link to 10 mbps speed.
100 — Sets the link to 100 mbps speed.
1000 — Sets the link to 1000 mbps speed.
Page 228
1536 — 65535 in decimal or hex formats.
7710 SR OS Interface Configuration Guide
Advertisement
Table of Contents
