Related
Documentation
Installing an MX2020 MIC
Copyright © 2015, Juniper Networks, Inc.
Figure 162: Installing the Standard Lower Cable Manager
Removing the MX2020 Lower Cable Manager on page 438
To install a MIC (see
Figure 164 on page
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
If you have used a dual-wide MIC and are now replacing it with two single-wide MICs,
2.
install the septum (see
Place the MPC on a flat surface (if necessary, remove the MPC from the ADC as
a.
described in
"Removing an MX2020 MPC from the Adapter Card" on page
Position the septum in the center of the MPC so that it lines up with holes labeled
b.
S
on the top of the MPC.
Insert a screw into each of the two holes labeled
c.
completely.
On the bottom of the MPC, insert a screw into each of the four holes labeled
d.
then tighten them completely.
Install the MPC as described in
e.
on page
492.
Chapter 22: Installing and Replacing Components
317):
Figure 163 on page 316
):
"Installing an MX2020 MPC into an Adapter Card"
487.
, and then tighten them
S
S
, and
315