Monitor Setting Display - Delta ASD-B2-0121-B User Manual

Chapter 4 Display and Operation
Display Message

4.3.5 Monitor Setting Display

When the AC servo drive is applied to power, the LCD display will show the monitor
function codes for approximately one second and then enter into the monitor mode. In
monitor mode, in order to change the monitor status, the users can press UP or DOWN
arrow key or change parameter P0-02 directly to specify the monitor status. When the
power is applied, the LCD display will show ASDB2 first and then display the monitor
status depending on the setting value of P0-02. For example, if the setting value of P0-02
is 4 when the power is applied, the monitor function will be input pulse number of pulse
command. After ASDB2 shows on the LCD display, the C-PLS monitor codes will display
next and then the pulse number will display after.
P0-02
Display Message
Setting
0
1
2
3
4
5
6
7
8
9
4-4
Negative value display. Continuously press SHIFT key for
two seconds and then the positive(+) or negative(-) sign
can be switched. When the setting value exceeds its
setting range, the positive(+) and negative(-) sign can not
be switched. (The negative value display is for a decimal
negative value only. There is no negative value display
for a hexadecimal negative value.)
Motor feedback pulse number (after
electronic gear ratio is set)
Input pulse number of pulse
command (after electronic gear
ratio is set)
Position error counts between
control command pulse and
feedback pulse
Motor feedback pulse number
(encoder unit, 1600000 pulse/rev)
Input pulse number of pulse
command (before electronic gear
ratio is set) (encoder unit)
Position error counts (after
electronic gear ratio is set) (encoder
unit)
Input frequency of pulse command
Motor rotation speed
Speed input command
Speed input command
Description
Description Unit
[user unit]
[user unit]
[user unit]
[pulse]
[pulse]
[pulse]
[Kpps]
[r/min]
[Volt]
[r/min]
Revision June 2010