Delta ASD-B2-0121-B User Manual page 80

P0-02
Display Message
Setting
10
11
12
13
14
15
16
17
18
The following table lists the display examples of monitor value:
Display Message
(Dec.)
(Hex.)
(Dec. High Byte)
(Dec. Low Byte)
(Hex. High Byte)
(Hex. Low Byte)
Revision June 2010
Description
Torque input command
Torque input command
Average load
Peak load
Main circuit voltage
Ratio of load inertia to Motor inertia
(Please note that if the display is
130, it indicates that the actual
inertia is 13.0)
IGBT temperature
Resonance frequency (The low byte
is the first resonance point and the
high byte is the second resonance
point.)
Absolute pulse number relative to
encoder (use Z phase as home). The
value of Z phase home point is 0,
and it can be the value from -5000
to +5000 pulses.
Decimal display. When the actual value is
1234, the display is 01234.
16-bit
Data
Hexadecimal display. When the actual value is
0x1234, the display is 1234.
Decimal display. When the actual value is
1234567890, the display of high byte is
1234.5 and the display of low byte is 67890.
32-bit
Data
Hexadecimal display. When the actual value is
0x12345678, the display of high byte is h1234
and the display of low byte is L5678.
Negative value display. When the actual value is -
12345, the display is 1.2.345. (The negative value
display is displayed to indicate a decimal negative
value. There is no negative value display for a
hexadecimal negative value.)
Chapter 4 Display and Operation
Description
Unit
[Volt]
[%]
[%]
[%]
[Volt]
[0.1times]
[ o C]
[Hz]
-
4-5