Position Control Mode; Command Source Of Position (Pt) Control Mode - Delta ASD-B2-0121-B User Manual

Chapter 6 Control Modes of Operation

6.2 Position Control Mode

The position control mode is usually used for the applications requiring precision positioning,
such as industry positioning machine, indexing table etc. The external pulse train with
direction which can control the rotation angle of servo motor. The max. input frequency for
the external pulse command is 4Mpps.
For the closed-loop positioning, speed control loop is the principal part and the auxiliary
parameters are position loop gain and feed forward compensation. The users can also select
two kinds of tuning mode (Manual/Auto modes) to perform gain adjustment. This Section 6.2
mainly describes the applicability of loop gain adjustment and feed forward compensation of
Delta servo system.

6.2.1 Command Source of Position (PT) Control Mode

The command source of P mode is external pulse train input form terminals. There are
three types of pulse input and each pulse type is with·logic type (positive (+), negative (-)).
They all can be set in parameter P1-00. Please refer to the following relevant parameters:
P1 - 00▲ PTT External Pulse Input Type
Default: 2
Applicable Control Mode: PT
Unit: N/A
Range: 0 ~ 1132
Data Size: 16bit
Display Format: HEX
Settings:
B: Input pulse filter
This setting is used to suppress or reduce the chatter caused by the noise, etc.
However, if the instant input pulse filter frequency is over high, the frequency that
exceeds the setting value will be regarded as noise and filtered.
B
0
1
2
3
6-2
A
B
C
not used
Low Filter Setting Value
1.66Mpps
416Kpps
208Kpps
104Kpps
Communication Addr.:
Related Section:
Section 6.2.1
• Value A: Pulse type
A=0: AB phase pulse (4x)
A=1: CW + CCW pulse
A=2: Pulse + Direction
Other settings:
High Filter
0 6.66Mpps
1 1.66Mpps
2 833Kpps
3 416Kpps
0100H, 0101H
Revision June 2010