This parameter is used to delay the communication time that servo drive responds to host
controller (external controller).
When this parameter is set to 0, it indicates that the communication time that servo drive
responds to host controller (external controller) will no be delayed.
0310H
0311H
Monitor Mode
This parameter is used to monitor the data of the servo drive via RS-485/232 device. The
monitor data can be displayed on PC upon the data scope function provided by ASDA-B2-
Soft software.
Revision June 2010
Default: 0000
Range: 0~1000
Byte
-
Function
-
Range
0
Setting:
H:
0: Disabled, i.e. disable monitor function.
1: Reserve
2: High-speed monitor mode. The sampling time is 2000 times
per second and 4 channels can be monitored.
3: High-speed monitor mode. The sampling time is 4000 times
per second and 2 channels can be monitored.
Chapter 8 MODBUS Communications
-
-
Monitor
-
-
0
0
H
mode
0 ~ 3
8-7