Extension Blade Led Descriptions - IBM SAN512B-6 Installation, Service And User Manual

The following table describes the extension blade LED patterns and the
recommended actions for those patterns.
Table 11. Extension blade LED descriptions
LED purpose
Power
Status
GbE port status
Color
Steady green
No light (LED is off)
No light (LED is off)
Steady amber
Blinking amber and green.
Green
No light (LED is off)
Steady green
Blinking green
Steady amber
Status
Blade is operational.
Blade is not powered on.
Blade is either healthy or
does not have power.
Blade is faulty or
initializing.
Attention. Blade is not
seated correctly or is faulty.
Blade is operational.
Port has no incoming
power, or is offline.
Port is online but has no
traffic.
Port is online, with traffic
flowing through port.
Transceiver or port has
error or is faulty.
Chapter 6. Monitoring the switch
Recommended action
No action required.
Ensure that the blade is
firmly seated, with ejectors
pushed in fully to center of
blade and captive screw for
each ejector fully tightened.
Verify that the power LED
is on.
Ensure that the blade is
firmly seated and check the
status by entering the
slotShow command. If LED
remains amber, consult the
device supplier.
Pull the blade out and
reseat it. If LED continues
to flash, replace the blade.
No action required.
Verify that the power LED
is on, check the transceiver
and cable.
No action required.
No action required.
Change the transceiver or
reset the switch from the
workstation.
73