Installing A Power Supply; Removing And Installing Power Supply Assembly - IBM SAN512B-6 Installation, Service And User Manual

4. Grasp the handle and pull, sliding the power supply from the chassis and
Figure 49. Removing and installing power supply assembly
5. If you are not replacing the power supply and can leave the device operating,

Installing a power supply

About this task
To install a power supply, complete the following steps.
Procedure
1. If a filler panel is installed over the slot where you are installing the power
2. Grasp the handle and slide the new power supply into the chassis while
supporting the power supply from beneath as you remove it.
insert a filler panel into the slot and tighten captive screw to secure to chassis.
supply, remove the panel by loosening the captive screw located on the right
side of the panel. When the screw releases from chassis, pull on the screw to
lift the panel from the chassis slot.
supporting the power supply from beneath. Push the power supply into slot
until the connectors seat in the chassis backplane.
Chapter 11. Power Supply Assemblies
169