Removing And Installing The Blade Filler Panel - IBM SAN512B-6 Installation, Service And User Manual

3. Pull out the spring-loaded latch release at each end of the cover and slide each
Figure 55. Removing and installing the blade filler panel
4. Reinstall the chassis door. The door must be installed to meet EMI compliance.
latch towards the end of the cover. This should slide the latches into the chassis
and lock the panel in place. If not, the cover may not be seated fully into the
slot. Try unlatching both ends, pushing the cover firmly into the slot, then
latching both ends again.
Note: Be sure filler panels are securely latched. If not, high pressure from fan
operation may unseat blade from chassis connectors.
Chapter 13. Blade Filler Panels
183