Time And Items Required For Installation - IBM SAN512B-6 Installation, Service And User Manual

Time and items required for installation

You can set up and install the device in the following ways:
v As a standalone unit on a flat surface.
v In a 19-inch Electronic Industries Association (EIA) rack or in a
The following table describes the main installation and setup tasks, the estimated
time required for each, and the items required to complete the task for a device
that is fully populated with port blades. Configurations with fewer blades or ports
require less time. These time estimates assume a prepared installation site and
appropriate power and network connectivity.
Table 2. Facility requirements (continued)
Type Requirements
Rack (when Ensure that these airflow requirements are met:
rack-mounted)
v Plan to install the device with the air-intake side facing the cool
v Ensure that the airflow available at the air vents meets the
v Install the device with the airflow aligned with other devices in
Ensure that the following amount of space is available in the rack:
v 14 rack units (14U) high. 1U is equal to 4.45 cm (1.75 inches).
v 61.29 cm (24.09 inch) deep.
v 43.74 cm (17.22 inch) wide.
Ensure that the rack meets these additional requirements:
v Additional weight of chassis will not exceed the rack's weight
v The rack is secured to ensure stability in case of unexpected
telecommunications (Telco) rack using a rack mount kit. Refer to"Mounting
options" on page 17 for applicable rack mount kits.
air aisle. The device can be installed facing either direction if
serviceability and cooling requirements are met.
minimum requirements for the device.
the rack. Some devices have airflow running from port side to
nonport side and others have the opposite arrangement. Make
sure that the airflow for all devices moves in the same direction
to maximize cooling.
limits.
movement.
Chapter 2. Preparing for the Installation
11