Chapter 14. Cable Management Comb; Cable Management Comb Overview; Time And Items Required For Removal And Installation; Removing Cable Management Comb - IBM SAN512B-6 Installation, Service And User Manual

Chapter 14. Cable management comb

This chapter provides the following information:
v "Cable management comb overview"
v "Time and items required for removal and installation"
v "Removing cable management comb"
v "Installing cable management comb" on page 186

Cable management comb overview

Use the cable management comb to organize and route cables that are attached to
blade ports. The SAN512B-6 can continue to operate while removing or installing
the cable management comb.

Time and items required for removal and installation

The replacement procedure for the cable management comb takes less than five
minutes. A #1 Phillips screwdriver is required.

Removing cable management comb

About this task
Complete the following steps to remove the cable management comb.
Procedure
1. Remove the cables from the cable management comb and rearrange the cables
2. Unscrew and save the four (4) screws holding the comb to the device. Support
3. Remove the cable management comb.
© Copyright IBM Corp. 2017
around the comb.
the comb to prevent it from falling.
185