Removal And Replacement Of The Control Processor Blade (Cpx6) - IBM SAN512B-6 Installation, Service And User Manual

Figure 41. Removal and replacement of the control processor blade (CPX6)
8. If the blade is not being replaced by another blade, install a filler panel and
Installing a blade
About this task
Note: Read all of the instructions for replacing the CP blade before beginning the
procedure. Make sure that the same version of Fabric OS is installed on both CP
blades. Using different versions is not supported and may cause malfunctioning. If
the replacement CP blade has a different version of Fabric OS, bring both blades to
136
SAN512B-6 Installation, Service, and User Guide
reinstall the chassis door. The filler panel is required for proper chassis cooling.
The door is required to meet EMI compliance.