Step 3. Attach The Stabilizers; Adjusting The Leveling Feet - IBM SAN512B-6 Installation, Service And User Manual

| |
|
Jam Nut
Leveling Screw
Front of Cabinet
|
|
Figure 62. Adjusting the leveling feet
|

Step 3. Attach the stabilizers

|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Rear of Cabinet
DANGER
You must firmly attach the stabilizers to the bottom front and
bottom rear of the rack to prevent the rack from turning over when
the switches are pulled out of the rack. (R001)
1. Align the slots in the stabilizer with the mounting holes at the bottom front of
the rack. See Figure 63.
Mounting Hole
Mounting Screw
Stabilizer
Figure 63. Stabilizers
2. Install the two mounting screws.
3. Ensure that the base of the stabilizer rests firmly on the floor. Use the Allen
wrench that is supplied with the rack to alternately tighten the mounting
screws until they are tight.
SJ000655
Front of Cabinet
Mounting Screw
Rear of Cabinet
Allen Wrench
SJ000656
211
Appendix A. SAN rack