Rack Nut Installation; Rail Extension - IBM TotalStorage DS4300 Installation, User's, And Maintenance Manual

1. Use the attached template and stickers to mark the appropriate holes on the
rack; then install clip nuts or cage nuts as required for the rack cabinet.
Note: Use the cage-nut-insertion tool or a flat-blade screwdriver to install cage
nuts.
5
5
Clip
Clip
nuts
n uts
Figure 8. Rack nut installation
2. On the rail marked R, remove the 6/32 in. screw 3 and loosen the four screws
2 ; then hold the front of the rail against the outside of the right
rack-mounting-flange and loosely install two M6 screws 1 .
Extend the rear of the rail outside of the rear rack-mounting-flange; then install
and tighten two M6 screws 4 . Tighten the front screws 1 and repeat this
step for the other rail.
6
6
Figure 9. Rail extension
3. Tighten the rail adjustment screws 1 on both rails.
Cage
Cage
nuts
n uts
Cage
Cage
nuts
n uts
Chapter 2. Installing and configuring the storage subsystem
25