Step 10. Connect Switch And Device Cables; Step 11. Power On The Rack; Power Cord Cabling (Rack Side View) - IBM SAN512B-6 Installation, Service And User Manual

|
|
| Figure 70. Power cord cabling (rack side view)
|
|
|

Step 10. Connect switch and device cables

|
|
|
|
|
|

Step 11. Power on the rack

|
|
|
|
|
Attention: To ensure proper air circulation and cooling, filler panels (see "Blank
fillers" on page 228) must be installed in all blank spaces in the rack.
The factory configures the rack and installs all of the director power cables.
The factory does not install switches or routers. These products should be installed
only by qualified personnel.
If you need to install device cables, follow the installation instructions provided
with the component that you are installing.
Perform the following steps to power on the rack:
1. Plug all power cords into the outlets on the power distribution units (iPDUs).
2. Plug the power cord of each iPDU into the customer's ac power outlets. Use
only the cords supplied with the rack and iPDUs.
SJ002016
221
Appendix A. SAN rack