Removing The Protective Cover; Attaching Trays To The Device - IBM SAN512B-6 Installation, Service And User Manual

6. Use four screws (Item 5) to attach each side of the front tray to the device
7. Use six screws (Item 5) to attach the lip on each side of the front tray to the lip
Figure 13. Attaching trays to the device
8. Reinstall the device door. For instructions, refer to the door removal and

Removing the protective cover

About this task
The chassis ships with a protective cover installed over the air vents at the top of
the port side of the chassis.
34
SAN512B-6 Installation, Service, and User Guide
on the front of the device.
Note: Do not use the top or bottom holes of the mounting bracket because the
door will interfere with the screw heads.
installation instructions in your device installation guide.