Removing The Wwn Card And Bezel - IBM SAN512B-6 Installation, Service And User Manual

10. On the active CP blade, run the wwnrecover command and specify WWN 2
11. If wwnrecover messages prompt for a system reboot, reboot both CP blades to
12. Verify the new card settings by running the following commands and
13. Run the switchcfgpersistentenable command to persistently enable each
14. Install the WWN bezel on the chassis.
15. Pack faulty WWN card assemblies in the packaging provided with the

Removing the WWN card and bezel

About this task
Two WWN cards located behind the WWN bezel. As you are facing the bezel on
the non-port-side of the device, WWN 1 is located on the left side, and WWN 2 is
on the right. When cards have been determined faulty and the replacement WWN
cards have been received, complete the following steps to remove the bezel and
faulty WWN cards.
Note: Unless the device is powered down and not operational, do not perform
these steps without first performing procedures under either "Hot-swap
replacement" on page 153 or "Cold-swap replacement" on page 154.
Procedure
1. Remove the two screws from the WWN bezel on the back of the device using a
2. Unscrew the captive screw for the WWN card assembly using a Phillips
3. Grasp the pull tab for a WWN card assembly and gently pull to release the
156
SAN512B-6 Installation, Service, and User Guide
card for recovery when prompted in wwnrecover output messages. Refer to
"Using the wwnrecover utility" on page 151 for more information on this
command.
ensure the system is running with valid WWN card data.
comparing the output with the original supportsave data:
v licenseidshow
v ipaddrshow
v switchname
v chassisname
v wwncardshow ipdata
v chassisshow (look at the WWN and chassis information at the bottom)
logical switch, that was disabled before removing the WWN card(s):
switch:FID128:root> switchcfgpersistentenable
Switch's persistent state set to 'enabled'
a. Orient the bezel on the chassis.
b. Insert and tighten both screws using a Phillips screwdriver.
replacement cards, and return them to Support for failure analysis (FA).
Phillips screwdriver. Pull the bezel away from the chassis and set it aside. The
ends of both WWN card assemblies with pull tabs are now visible.
screwdriver until the assembly releases from chassis.
assembly from backplane connector. Carefully slide the card assembly out from
the chassis slot. Use both hands to support the card assembly along its length
as you remove it from the slot.