Chapter 15. Chassis Door; Chassis Door Overview; Time And Items Required; Removing A Chassis Door - IBM SAN512B-6 Installation, Service And User Manual

Chapter 15. Chassis door

This chapter provides the following information:
v "Chassis door overview"
v "Time and items required"
v "Removing a chassis door"
v "Installing a chassis door" on page 188

Chassis door overview

The chassis door must be installed to ensure that the device meets EMI and other
regulatory certifications. A receiving hole is located on each corner on the back side
of the door. Each hole snaps into a ball stud located on a matching corner of the
chassis.

Time and items required

The first-time installation procedure for the chassis door takes 15 minutes or longer
because you must remove the protective cover and install ball studs to mount the
door. Thereafter, removal and reinstallation should take less than 5 minutes.
Required for installation are the door assembly, packaged separately from the
chassis, and ball studs for the door. Ball studs are packaged with the door
assembly.

Removing a chassis door

Support the door to prevent it from falling. Pull and remove the door. It will pop
off the ball studs.
© Copyright IBM Corp. 2017
187