Lifting Precautions - IBM SAN512B-6 Installation, Service And User Manual

Lifting precautions

CAUTION:
Use safe lifting practices when moving the product.
18-32 kg (39.7-70.5 lbs)
CAUTION:
A fully populated chassis weighs approximately 145.83 kg (321.5 lbs)
and requires a hydraulic or assisted lift to install it.
18-32 kg (39.7-70.5 lbs)
Note: Do not attempt to lift the device by the protective cover attached
to the air vents on the nonport-side of the chassis.
18-32 kg (39.7-70.5 lbs)
DANGER
If a lift tool with a capacity of at least 350 lb is not available, the
director chassis must be depopulated completely before installing
18-32 kg (39.7-70.5 lbs)
it into the rack. Remove the power supplies, fan modules, all of the
blades, the cable management comb, and the chassis door (if
equipped). Install the empty chassis into the rack following the
chassis installation instructions. The weight of the empty chassis is
78.5 lb (35.6 kg) and must be lifted by minimum 3 people. After
securing the chassis to the rack, reinstall the power supplies, fan
modules, and the blades and proceed with the installation.
Laser precautions
DANGER
All fiber-optic interfaces use Class 1 lasers.
DANGER
Laser Radiation. Do Not View Directly with Optical Instruments.
Class 1M Laser Products.
DANGER
Use only optical transceivers that are qualified by Brocade
Communications Systems, Inc. and comply with the FDA Class 1
radiation performance requirements defined in 21 CFR Subchapter
I, and with IEC 825 and EN60825. Optical products that do not
comply with these standards might emit light that is hazardous to
the eyes.
Chapter 2. Preparing for the Installation
9