Sfpshow - IBM SAN512B-6 Installation, Service And User Manual

Following is an example of slotShow output.
Note: The most common status is shown. A status of Faulty (51) would display
for a POST failure during power-on or a blade hot-plug.
chassis:admin> slotShow -m
Slot Blade Type
--------------------------------------------------
1 CP BLADE
2 CP BLADE
3 SW BLADE
4 SW BLADE
5 AP BLADE
6 SW BLADE
7 CORE BLADE
8 CORE BLADE
9 SW BLADE
10 UNKNOWN
11 SW BLADE
12 SW BLADE
switch:admin>

sfpShow

Use this command without operands to display a summary of all installed SFPs.
For each port, the command displays the SFP type and, for serial ID SFP, the
vendor name and SFP, serial number, and speed capability (in Gbps). Use this
command with a port number to display detailed information about the serial ID
SFP in the specified port.
Following is example of sfpShow output.
chassis:admin> sfpshow
Slot 3/Port 0: --
Slot 3/Port 1: --
Slot 3/Port 2: --
Slot 3/Port 3: --
Slot 3/Port 4: --
Slot 3/Port 5: --
Slot 3/Port 6: --
Slot 3/Port 7: --
Slot 3/Port 8: --
Slot 3/Port 9: --
Slot 3/Port 10: --
Slot 3/Port 11: --
Slot 3/Port 12: --
Slot 3/Port 13: --
Slot 3/Port 14: --
Slot 3/Port 15: --
Slot 4/Port 0: --
Slot 4/Port 1: --
Slot 4/Port 2: --
Slot 4/Port 3: --
Slot 4/Port 4: --
Slot 4/Port 5: --
Slot 4/Port 6: --
Slot 4/Port 7: --
Slot 4/Port 8: --
Slot 4/Port 9: --
Slot 4/Port 10: --
Slot 4/Port 11: --
Slot 4/Port 12: --
Slot 4/Port 13: --
Slot 4/Port 14: --
Slot 4/Port 15: --
Slot 5/Port 0: --
Slot 5/Port 1: --
Slot 5/Port 2: --
Slot 5/Port 3: --
Slot 5/Port 4: --
Slot 5/Port 5: --
Slot 5/Port 6: --
ID Model Name Status
175 CPX6 ENABLED
175 CPX6 ENABLED
178 FC32-48 ENABLED
178 FC32-48 ENABLED
186 SX6 ENABLED
178 FC32-48 DISABLED
176 CR32-8 ENABLED
176 CR32-8 ENABLED
178 FC32-48 ENABLED
VACANT
178 FC32-48 ENABLED
178 FC32-48 ENABLED
Chapter 6. Monitoring the switch
93