Chapter 17. Removing The Battery; Location Of Battery Holder - IBM SAN512B-6 Installation, Service And User Manual

Chapter 17. Removing the battery

CAUTION:
The battery contains lithium. To avoid possible explosion, do not burn or charge
the battery. Do not:
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
Exchange only with the IBM-approved part. Recycle or discard the battery as
instructed by local regulations. In the United States, IBM has a process for the
collection of this battery. For information, call 1-800-426-4333. Have the IBM part
number for the battery unit available when you call. (C003)
Local regulations may require removing the battery prior to disposing of or
recycling this product. Complete these steps to remove the battery.
1. Disconnect all power and communication cables.
2. Remove all transceivers.
3. Remove the power supplies and fans.
4. Unscrew the fasteners and remove the sheetmetal cover from the chassis.
5. On the main circuit board, go to location 1 shown in Figure 60 and remove
Figure 60. Location of battery holder
6. Recycle the battery as appropriate, following local regulations.
© Copyright IBM Corp. 2017
the BR1225 battery from the holder.
1
207