IBM SAN512B-6 Installation, Service And User Manual page 57

Procedure
1. Ensure that the door is removed from the port side of the device. For
2. Orient the device (refer the following figure) and use a hydraulic lift to raise it
3. If applicable, lock the wheels of the lift.
4. Slide the device into the trays until the front edge of the device is seated
Figure 12. Placing the device in the trays
5. Use three screws (Item 5) to attach each side of the rear tray to the device (refer
instructions, refer to the door removal and replacement procedures in your
device installation guide.
to the level of the trays.
against the front tray.
1 - Tray, front, mid-mount, chassis
2 - Tray, rear, mid-mount, chassis
the following figure).
Note: The screw holes in the device walls have pem nuts on the inside surface.
Chapter 3. Mounting the Device
33