Cpx6 Port Identification; Cpx6 Blade Port Identification - IBM SAN512B-6 Installation, Service And User Manual

easily locate the blades and chassis in an equipment rack. To enable or disable
beaconing on both blades, log into the chassis and enter the chassisbeacon
command as follows:
v To enable beaconing:
v To disable beaconing:
v
For details on LED location and operation, refer to "Interpreting control processor
blade LEDs" on page 74.

CPX6 port identification

The following illustration identifies connector ports on the CPX6 blade.
1 - 10 Gbps Base-T RJ45 Ethernet port (reserved for future use)
2 - USB port for firmware download and logs
3 - Serial console RJ45 port
4 - 10/100/1000Base-T RJ45 Ethernet port for chassis management and configuration
5 - 10/100/1000Base-T RJ45 Ethernet port for service
Figure 40. CPX6 blade port identification
130
SAN512B-6 Installation, Service, and User Guide
chassis:admin> chassisbeacon 1
chassisBeacon success 1
chassis:admin> chassisbeacon 0
chassisBeacon success 0
To display beaconing status:
Note: Value in the following example shows 0 when beaconing is off and 1 if
beaconing is on.
chassis:admin> chassisbeacon
Value = 0