Precautions Specific To The Blade - IBM SAN512B-6 Installation, Service And User Manual

Figure 38. Core-edge ICL topology
SAN512B-6 and SAN384B-2 or SAN768B-2 can also be connected in a full-mesh
configuration.
For details on the following subjects, refer to the "Inter-Chassis Links' section of
theFabric OS Administrator's Guide:
v ICL topologies
v ICL trunking
v Configuring ICLs between SAN512B-6 and SAN256B-6
v Configuring ICLs between SAN512B-6 or SAN256B-6 and SAN384B-2 or

Precautions specific to the blade

This document describes how to remove and replace a core routing blade.
Observe the following precautions when replacing these blades:
v The CR32-8 core routing blade is compatible only with the SAN512B-6 .
v Wear an appropriately grounded ESD wrist strap when handling and installing
v Install core routing blades only in slots 7-8. These blades cannot be installed in
122
SAN512B-6 Installation, Service, and User Guide
SAN768B-2 models
blades and cards. Follow electrostatic discharge (ESD) precautions. Wear a wrist
grounding strap connected to chassis ground (if the chassis is plugged in) or a
bench ground.
other slots as guide pins and connectors in each slot allow only specific blade
types.