Establishing An Ethernet Connection To The Device; Port - IBM SAN512B-6 Installation, Service And User Manual

3. Set up the CP0 IP address by entering the ipaddrset -cp 0 command:
4. Set up the CP1 IP address by entering the ipaddrset -cp 1 command:

Establishing an Ethernet connection to the device

About this task
After using a serial connection to configure the IP addresses for the device, you
can connect the active CP blade to the local area network (LAN).
Note: Connecting the CP blades to a private network or VLAN is recommended.
After establishing an Ethernet connection, you can complete the device
configuration using a serial console connection, Telnet connection, or management
applications, such as Web Tools or IBM Network Advisor.
Perform the following steps to establish an Ethernet connection to the device.
Procedure
1. Remove the shipping plug from the Ethernet port on the active CP blade. The
2. Insert one end of an Ethernet cable into the Management (MGMT) Ethernet
3. Connect the other end to an Ethernet 10/100/1000 BaseT LAN.
4. Complete any additional device configuration procedures for the device using
Following is example configuration for setting the chassis IP address.
swDir:admin> ipaddrset -chassis
DHCP [Off]:
Ethernet IP Address [10.0.0.0]:192.168.1.1
Ethernet Subnetmask [255.0.0.0]:255.255.240.0
IP address is being changed...
swDir:admin> ipAddrSet -cp 0
Enter required information at the prompts. Following is example configuration
for setting the CP0 IP address
swDir:admin> ipaddrset -cp 0
DHCP [Off]:
Host Name [cp0]:
Ethernet IP Address [10.0.0.0]:192.168.1.2
Ethernet Subnetmask [255.0.0.0]:255.255.260.0
Gateway IP Address [10.0.0.0]:10.38.160.1
IP address is being changed...
Done.
swDir:admin> ipAddrSet -cp 1
Enter required information at the prompts. Following is example configuration
for setting the CP1 IP address.
Following is sample configuration for setting the CP1 IP address:
swDir:admin> ipaddrset -cp 1
DHCP [Off]:
Host Name [cp0]:
Ethernet IP Address [10.0.0.0]:192.168.3
Ethernet Subnetmask [255.0.0.0]:255.255.230.0
Gateway IP Address [10.0.0.0]:10.38.160.1
IP address is being changed...
Done.
active CP is indicated by an illuminated blue LED on the blade front panel.

port.

one of the following steps:
v Log into the device using a serial console connection and admin login.
Chapter 4. Initial Setup and Verification
49