IBM SAN512B-6 Installation, Service And User Manual page 228

Procedure
1. Remove the chassis door ("Removing a chassis door" on page 187) if not
2. Remove the cable management comb ("Removing cable management comb" on
3. Remove the port, extension, blades or filler panels ("Removing a blade" on
4. Remove the core routing blades ("Removing a core routing blade" on page
5. Remove the control processor blades ("Removing a blade" on page 135).
6. Remove the power supply assemblies or filler panels ("Removing a power
7. Remove the fan assemblies ("Removing a fan assembly" on page 178).
Installing the replacement chassis
About this task
Complete the following steps to install the replacement chassis.
Procedure
1. If the chassis is in a rack, remove it from the rack.
2. Place the chassis on a lift or on the shipping pallet provided with the original
3. Unpack the new chassis.
204
SAN512B-6 Installation, Service, and User Guide
DANGER
For safety reasons, the ESD wrist strap should contain a series 1
megaohm resistor.
already removed.
page 185).
page 111 and "Removing a filler panel" on page 181).
124).
supply" on page 168).
DANGER
Use safe lifting practices when moving the product.
18-32 kg (39.7-70.5 lbs)
DANGER
A completely empty chassis weighs approximately 24.49 kg (54.0 lb)
and requires a hydraulic or assisted lift to install it.
18-32 kg (39.7-70.5 lbs)
DANGER
Make sure the rack housing the device is adequately secured to
prevent it from becoming unstable or falling over.
18-32 kg (39.7-70.5 lbs)
chassis and transport to storage location.
a. Cut the bands that encircle the packaging.