Installing A Fan Assembly; Removing And Installing A Fan Assembly - IBM SAN512B-6 Installation, Service And User Manual

4. Grasp the handle and pull, sliding the fan assembly from the chassis while
Figure 53. Removing and installing a fan assembly
5. If leaving power on for replacement (hot swap), be sure to replace the fan

Installing a fan assembly

About this task
Complete the following steps to replace the fan assembly in a device.
Procedure
1. Grasp the handle and carefully slide the fan assembly into the device while
2. Push the fan assembly fully into the slot with your fingers until it seats in the
3. Verify that the power LED displays a green light.
4. Push in on each captive screw and tighten with #1 Phillips screwdriver to
supporting the fan assembly from beneath as you remove it.
assembly as soon as possible.
supporting the fan assembly from beneath.
backplane connectors.
secure the fan assembly to the chassis.
Note: Be sure that captive screws are tightened. If not, high pressure from fan
operation may unseat fan from chassis connectors.
Chapter 12. Fan Assemblies
179