Installing A Filler Panel; Removing And Installing The Blade Filler Panel - IBM SAN512B-6 Installation, Service And User Manual

Figure 54. Removing and installing the blade filler panel

Installing a filler panel

About this task
Complete the following steps to install a filler panel into a blade slot.
Procedure
1. Pull out the spring-loaded latch release on the latch at each end of the cover
2. Orient the filler panel over the empty slot and slide into the slot.
182
SAN512B-6 Installation, Service, and User Guide
1 - Latch pull tab
2 - Latch release
using your thumb and forefinger and slide the latches toward the center of the
cover.