IBM SAN512B-6 Installation, Service And User Manual page 220

196
SAN512B-6 Installation, Service, and User Guide
Table 22. Critical information checklist (continued)
Checked?
Information about the new chassis
2. Open a telnet session and log into the device as admin. The default password
is password. Enable the logging function on your telnet or serial console
connection.
3. Back up the current configuration by entering configUpload. Enter the
requested information at the prompts.
Note: If you are using the Virtual Fabric feature, run configupload -vf
before running the configupload command to save the logical switch
configuration.
This configUpload command uploads the device configuration to the
customer-defined FTP server, making it available for downloading.
Alternatively, you can save the configuration file to a USB device. For more
information about this command, refer to the Fabric OS Command Reference.
switch:admin> configupload
Protocol (scp, ftp, sftp, local) [ftp]: ftp
Server Name or IP Address [host]: 123.123.123.123
User Name [user]: Admin24
Path/Filename [<home dir>/config.txt]: config-switch0.txt
Section (all|chassis|switch [all]): all
Password:
Upload complete
switch: admin>
4. Record the WWN value: Enter wwn, and then copy the command output into a
file named config-miscinfo.txt.
switch:admin> wwn
10:00:00:60:69:00:00:0a
5. Enter ipAddrShow -sw, and then copy the command output into the
config-miscinfo.txt file.
switch:admin> ipaddrshow -sw
SWITCH
Ethernet IP Address: 14.25.60.14
Ethernet Subnetmask: 255.55.0.0
Fibre Channel IP Address: 1.2.3.4
Fibre Channel Subnetmask: 255.255.255.0
CP0
Ethernet IP Address: 14.25.60.10
Ethernet Subnetmask: 255.55.0.0
HostName : cp0
Gateway Address: 14.25.43.1
CP1
Ethernet IP Address: 14.25.50.13
Ethernet Subnetmask: 255.55.0.0
HostName : cp1
Data
Location of "spptshow.txt"
file
Notes regarding supportshow
output
New factory serial number
New serial number (if
available)
Notes