Removing Fiber-Optic Cable Protective Caps; Inserting An Lc-Lc Fibre-Channel Cable Into An Sfp Module - IBM TotalStorage DS4300 Installation, User's, And Maintenance Manual

|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
38
IBM TotalStorage DS4300 Fibre Channel Storage Subsystem: Installation, User's, and Maintenance Guide
Fibre-optic
cable
Figure 25. Removing fiber-optic cable protective caps
4. Carefully insert this end of the LC-LC cable into an SFP module that is installed
in the DS4700. The cable connector is keyed to ensure it is inserted into the
SFP module correctly. Holding the connector, push in the cable until it clicks into
place, as shown in Figure 26.
Figure 26. Inserting an LC-LC fibre-channel cable into an SFP module
5. Remove the two protective caps from the other end of the LC-LC cable. Save
the protective caps for future use.
6. Connect this end of the LC-LC cable to one of the following devices:
v An SFP module that is installed in a separate IBM DS4000 EXP storage
expansion enclosure
v An SFP module that is installed in a fibre channel switch port
v A fibre channel host bus adapter port
Protective cap