Removing The Scsi Backplane Assembly; Removing The Hot-Swap Hard Disk Drive Backplane - IBM TotalStorage 300 Service Manual

Removing the SCSI backplane assembly

To remove the hot-swap hard disk drive backplane:
1. Remove the cover.
2. Disconnect cables.
3. Remove the screw 1 from the top of the assembly.
4. Gently slide the SCSI backplane assembly 2 up to remove.

Removing the hot-swap hard disk drive backplane

To remove the hot-swap hard disk drive backplane:
1. Remove the cover.
2. Pull out the hard drives in order to disconnect them from the backplane.
3. Remove the screw from the top of the backplane bracket 1 .
1
Screw
2
SCSI Backplane
1
Backplane bracket
2
Backplane board
3
Screws (4)
Appendix A. FRU information (service only)
123