Table of Contents
Advertisement
Figure 73. Removing and installing a fan assembly
5. If leaving power on for replacement (hot swap), be sure to replace the fan assembly as soon as
possible.
Installing a fan assembly
About this task
Complete the following steps to replace the fan assembly in a device.
Procedure
1. Grasp the handle and carefully slide the fan assembly into the device while supporting the fan
assembly from beneath.
2. Push the fan assembly fully into the slot with your fingers until it seats in the backplane connectors.
3. Verify that the power LED displays a green light.
4. Push in on each captive screw and tighten with #1 Phillips screwdriver to secure the fan assembly to
the chassis.
Note: Be sure that captive screws are tightened. If not, high pressure from fan operation may unseat
fan from chassis connectors.
Verifying fan operation
About this task
Perform the following tasks to verify operation of a fan assembly:
176
SAN256B-6 Installation, Service, and User Guide
Advertisement
Table of Contents
