Replacing Staple Cartridge (For Finisher-C1 With Booklet Maker) - Fuji Xerox apeosport-iv C5570 Administrator's Manual

3 Maintenance
2
Hold the tabs on both sides of the staple
cartridge and pull the cartridge out of the
finisher.
3
Hold the tabs on both sides of a new staple
cartridge, and insert it into the original posi-
tion until it clicks.
3
4
Repeat steps 2 and 3 to replace the other staple cartridge.
5
Close the finisher side cover.
Note

Replacing Staple Cartridge (for Finisher-C1 with Booklet Maker)

When the optional Finisher-C1 with Booklet Maker is installed and the staple cartridge
needs to be replaced, a message appears on the touch screen. When this message
appears, load a new staple case into the staple cartridge.
Important • The use of staple cartridges not recommended by Fuji Xerox may degrade quality and
Note
1
Make sure that the machine is not operating,
and open the finisher front cover.
2
While pressing the handle R2 and handle R3
to the right (1), take the staple cartridge unit
out of the finisher (2).
74
• If the cover is not completely closed, a message will appear and the machine remain
paused.
performance. Use only staple cartridges recommended by Fuji Xerox.
• To order a staple cartridge, contact our Customer Support Center.
R3
R2