Fuji Xerox apeosport-iv C5570 Administrator's Manual page 214

5 Tools
Save Deleted Faxes
When [Yes] is selected for [Save Undelivered Faxes], set whether or not to save cancelled
faxes.
Saved Faxes - Auto Delete
When [Yes] is selected for [Save Undelivered Faxes], set whether or not to automatically
delete saved faxes in 24 hours.
Transmission Interval
Specify a value for the interval between the end of one transmission and the beginning of the
next, from 3 to 255 seconds in 1 second increments.
A longer transmission interval increases the total time to send a broadcast transmission, but
allows calls to be received during the standby time.
Batch Send
When the machine stores multiple faxes addressed to a destination, enabling the Batch Send
feature allows you to send them all at the same time in a single fax transmission. By using
this feature, you can reduce your communication costs.
Select whether or not to enable the Batch Send feature.
Note that a batch send is not available for manual transmissions, broadcasts, relay
broadcasts, remote folder, and delayed start transmission with a specified time before the
specified time. When a redial, resend, delayed start transmission job, or the Authentication
feature is used and different users send to the same address, a batch send is not possible.
5
Manual Send/Receive Default
When on-hook or off-hook is used when sending a fax, select either [Manual Receive] or
[Manual Send].
Fax Receiving Mode
Set the default value for [Fax Receiving Mode] in the [Machine Information] screen displayed
by pressing the <Machine Status> button. Select whether or not to receive a fax automatically
or manually.
Border Limit
Set the length to make a page break that will be applied when the length of a received fax
document is longer than the paper length. You can specify a value from 0 to 127 mm in 1 mm
increments.
This setting can conveniently be used together with the following Auto Reduce on Receipt
feature.
Auto Reduce On Receipt
When the length of a received fax document exceeds the paper length but is within the page
break threshold value, select whether or not to automatically reduce the image to fit the page.
This setting can conveniently be used together with the Border Limit feature. If you select
[No], the part of the image beyond the paper length is ignored.
Receiving Paper Size
Set the method of notifying the paper size on which the received fax document will be printed,
from the receiver to the sender.
Tray Mode
Specify the paper tray for printing the received fax document. Only the specified paper tray
will be used for printing the received document. Multiple paper trays can be specified except
for Tray 5. If the fax document cannot be printed on the paper loaded on the specified paper
trays, the machine displays a message stating that it will be printed on the paper loaded in
212