Fuji Xerox apeosport-iv C5570 Administrator's Manual page 296

7 Printer Environment Settings
4
Select [Close].
Note
5
Print a configuration report to confirm that the NetWare port is enabled, and confirm
the NetWare device name and the network address.
For information on how to print a configuration report, refer to "Print Reports" (P.95).
6
Configure the machine using the Driver CD Kit.
For information on the settings, refer to the manual contained in the Driver CD Kit.
Using an LPD Port in NDPS
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
Note
3) Select [Tools] on the [Services Home] screen.
2
Enable the LPD port.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
7
3) Select [LPD], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
6) Select [Close] repeatedly until the [Tools] screen is displayed.
3
Set an IP address and the other addresses.
Skip this step if an IP address is already set.
If DHCP or BOOTP is available in your environment, configure the method for
obtaining the address. The configuration of an IP address, a subnet mask, and a
gateway address is not required.
For information on how to set an IP address, refer to "Protocol Settings" (P.178).
4
Select [Close] repeatedly until the [Tools] screen is displayed.
5
Select [Close].
Note
6
Print a configuration report to confirm that the LPD port is enabled and that TCP/IP is
set up correctly.
For information on how to print a configuration report, refer to "Print Reports" (P.95).
Configure other LPD settings as necessary. For information on the LPD settings, refer to "Installation
When Using TCP/IP (LPD/Port 9100)" (P.290).
7
Configure the machine using the Driver CD Kit.
For information on the settings, refer to the manual contained in the Driver CD Kit.
294
• Rebooting the machine may be required depending on the settings. When a message
displayed on the screen, follow the message and reboot the machine.
• The default user ID is "11111".
• The default passcode is "x-admin".
• Rebooting the machine may be required depending on the settings. When a message
displayed on the screen, follow the message and reboot the machine.