Original Size Defaults; Local Terminal Information - Fuji Xerox apeosport-iv C5570 Administrator's Manual

5 Tools

Original Size Defaults

You can set the original sizes displayed in [Original Size] in the [Layout Adjustment]
screen.
You can assign original sizes to the buttons other than [Auto Detect].
If you frequently use non-standard size paper for scanning, setting non-standard size
as the default will save your time to specify the size each time.
A/B Series Size
You can select from sizes of A and B series such as A4 and B5.
Inch Size
You can select from size of Inch series such as 8.5 x 11" and 11 x 17".
Others
You can select from sizes of other than the above series such as photo and postcard sizes.

Local Terminal Information

You can set the local terminal information, including a local name and company logo.
For information about how to enter characters, refer to "Entering Text" (P.31).
Note
5
Local Name
Register the name of the local terminal as the local name.
The local name is shown in the recipient's touch screen or Activity Report. Depending on the
recipient's device, however, it may not be displayed.
Specify a local name with up to 20 single-byte characters using the keyboard displayed or the
numeric keypad.
Company Logo
Register the sender name (company logo). The company logo is printed in the Transmission
Header Text or Cover Page. Specify a company log with up to 60 single-byte characters
using the keyboard displayed or the numeric keypad.
Note
Machine Password
Set the machine password when you want to limit the other parties that can send faxes.
When the machine password is set, only a party that sends the correct machine password by
F code is allowed to send or poll. Note that this means that faxes cannot be accepted from a
fax without the F Code feature.
Line 1 to 3 - Company Logo
Register the sender names for lines 1 to 3. The sender name is printed in the Transmission
Header Text or Cover Page. Enter up to 60 single-byte characters using the keyboard
displayed or the numeric keypad.
G3 Line 1 to 3 - Fax ID
When using G3 communications, register the G3 ID. The G3 ID is normally set to the local
terminal fax number.
Specify a G3 ID with up to 20 digits using the keyboard displayed or the numeric keypad.
216
• The displayed items may vary depending on the options installed.
• There are a maximum of three lines that can be used for G3 communications: line 1, line 2,
and line 3.
• For each line, you can set a company logo, G3 ID (fax number), G3 dial type, and G3 line
type.
• If [Line 1 to 3 - Company Logo] is not registered, the company log is used.