Replacing Staple Cartridge (For Finisher-C1 With Booklet Maker) - Fuji Xerox ApeosPort-IV C5575 Administration Manual

3 Maintenance
1
Make sure that the machine is not operating,
and open the finisher side cover.
2
Hold the tabs on both sides of the staple
cartridge and pull the cartridge out of the
finisher.
3
3
Hold the tabs on both sides of a new staple
cartridge, and insert it into the original position
until it clicks.
4
Repeat steps 2 and 3 to replace the other staple cartridge.
5
Close the finisher side cover.
Note

Replacing Staple Cartridge (for Finisher-C1 with Booklet Maker)

When the optional Finisher-C1 with Booklet Maker is installed and the staple cartridge needs
to be replaced, a message appears on the touch screen. When this message appears, load a
new staple case into the staple cartridge.
Important • The use of staple cartridges not recommended by Fuji Xerox may degrade quality and performance.
Note
1
Make sure that the machine is not operating,
and open the finisher front cover.
80
• If the cover is not completely closed, a message will appear and the machine remain paused.
Use only staple cartridges recommended by Fuji Xerox.
• To order a staple cartridge, contact our Customer Support Center.