Fuji Xerox apeosport-iv C5570 Administrator's Manual page 29

Setting the Screen Default
You can set the screen displayed when the machine is turned on or the Energy Saver
mode is deactivated. This section describes how to set up the [Copy] screen as the
initial screen, as an example.
1
Select [Screen Default], and then select [Change Settings].
2
Select [Copy].
Note • Select [
3
Select [Save].
Setting the Screen After Auto Clear
You can select the screen to be displayed after Auto Clear from [Last Selection Screen]
or [Services Home].
1
Select [Screen After Auto Clear], and then
select [Change Settings].
2
Select [Last Selection Screen] or [Services
Home].
3
Select [Save].
Customizing the [Services Home] Screen
You can customize the services and the button layout displayed on the [Services
Home] screen when you press the <Services Home> button on the control panel.
The following services are registered by the factory default.
Note • Service not supported by the machine will not be displayed on the screen. Buttons
Copy
Fax/Internet Fax
E-mail
Simple Copy
Simple Fax
Scan to PC
Store to Folder
Network Scanning (ApeosPort series
models only)
Store to USB
Send from Folder
Stored Programming
] to display the previous screen
or [ ] to display the next screen.
highlighted in gray cannot be used as a result of malfunctioning.
Customizing the Control Panel
Service buttons Additional feature
buttons
1
27