Fuji Xerox apeosport-iv C5570 Administrator's Manual page 524

14 Problem Solving
Error Code
C P F S M O
124-705
O
124-706
O
124-708
124-709
O
124-710
O
133-210
133-211
133-212
133-213
133-214
133-215
133-216
133-217
133-218
14
133-219
133-220
133-221
133-222
133-223
133-224
133-226
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
522
Category
[Cause]
[Remedy] Confirm the punch position, and then execute the
[Cause]
[Remedy] Confirm the folding setting, and then execute the operation
O [Cause]
[Remedy] For 1), check whether the specified size paper is loaded in
[Remedy] Contact our Customer Support Center. Any trays other
[Cause]
[Remedy] Reduce the number of pages, or cancel the stapling
[Cause]
[Remedy] No measure is required. The machine automatically
O [Cause]
[Remedy] Switch off the machine power, make sure that the touch
O [Cause]
[Remedy] Contact our Customer Support Center.
Cause and Remedy
The punch setting was cancelled.
operation again.
The folding setting was cancelled.
again.
The output destination was changed to the Center Tray.
The probable causes are as follows:
1) Paper of a different size from the specified is loaded for
2 sided copying.
2) The Punching feature of the Finisher has malfunctioned.
the tray.
For 2), confirm whether the error code 012-231, 012-232,
012-233, or 012-234 is displayed on the touch screen, and
contact our Customer Support Center.
than the defective output tray can be used.
The document exceeded the maximum number of pages
that can be stapled.
setting, then try printing again.
The machine cannot output to the output destination
specified. A paper size or a paper type that cannot be
output is specified or the output destination fails.
selects the available output destination. If the paper is not
still output from the specified output destination even after
the correct paper size and type is selected, contact our
Customer Support Center.
An error occurred during fax transmission.
screen is blank, and then switch on the machine power. If
the error still is not resolved, contact our Customer
Support Center.
A country code not supported by the machine was
specified.