Fuji Xerox apeosport-iv C5570 Administrator's Manual page 512

14 Problem Solving
Error Code
C P F S M O
033-571
033-572
033-574
033-575
033-576
033-577
033-578
033-710
033-712
033-713
033-716
033-717
033-718
14
033-719
033-721
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
510
Category
O [Cause]
[Remedy] Cancel the fax data in the queue, or wait for a while, and
O [Cause]
[Remedy] No measure is required. The data will be printed after a
O [Cause]
[Remedy] Specify an available line.
O [Cause]
[Remedy] Execute the operation again.
O [Cause]
[Remedy] Enter a correct fax number, and execute the operation
O [Cause]
[Remedy] Execute the operation again.
O [Cause]
[Remedy] Confirm the status of the line and the recipient machine,
O [Cause]
[Remedy] Store the document again.
O [Cause]
[Remedy] Delete unnecessary data.
O [Cause]
[Remedy] Contact our Customer Support Center.
O [Cause]
[Remedy] Register the folder.
Refer to "Create Folder" (P.234).
O [Cause]
[Remedy] Inform the correct information to the sender's machine.
O [Cause]
[Remedy] Store fax or polling documents into the folder as
O [Cause]
[Remedy] Retry sending.
O [Cause]
[Remedy] Switch off the machine power, make sure that the touch
Cause and Remedy
Cannot use the Fax service because of causes such as
memory is insufficient.
execute the operation again.
The data received is not printed.
while.
An unavailable line is specified.
An error occurred during fax transmission.
The recipient (fax number) is incorrect.
again.
An error occurred during fax transmission.
An error occurred during fax receiving.
and then ask the sender to send again.
The document to be sent by polling was deleted.
Unable to process because of insufficient memory.
An error occurred during fax transmission.
The folder specified from the sender's machine does not
exist.
The folder passcode specified from the sender's machine
is incorrect. Or, the machine passcode for reception is
incorrect.
Fax or polling documents do not exist in the folder
specified from the sender's machine.
necessary.
The document may be deleted by turning the machine off
and then on.
An error occurred during fax transmission.
screen is blank, and then switch on the machine power. If
the error still is not resolved, contact our Customer
Support Center.