Fuji Xerox apeosport-iv C5570 Administrator's Manual page 649

When [Receiving Buffer - SMB] is set to [Spool to Hard Disk]
All print data spooled in the machine hard disk, including the data which is being
printed, is saved. In this case, when the machine is turned on, the data stored on the
machine hard disk is printed before any jobs instructed subsequently.
When [Receiving Buffer - SMB] is set to [No Spooling]
All print data spooled in the machine receiving buffer, including the data which is
being printed, is erased. The print data does not remain when the machine is turned
on again.
However, if the machine was turned off immediately after a computer instructed a
print job, the job may remain on the computer. In this case, when the machine is
turned on, the data stored on the computer is printed before any jobs instructed
subsequently.
While Printing
When [Receiving Buffer - SMB] is set to either [Spool to Hard Disk] or [Spool to
Memory]
If the transmitted print data size exceeds the available capacity of either the hard disk
or memory, the print data is not received.
Note • When the print data exceeds the receivable size, some computers may immediately re-
transmit the print data. In this case, the computer appears to be not operating. Remedy this
problem by canceling the print data transmission from the computer.
When [Receiving Buffer - SMB] is set to [No Spooling]
When the machine receives a print request from a computer, the machine cannot
accept print requests from any other computers.
When a computer's IP address or a computer name is changed
When you change a computer's IP address or a computer name, queries and cancel
processes submitted from the machine are no longer executed correctly. Thus, turn
the machine off and on when there is no print data in the receiving buffer.
Note • From the control panel on the machine, you can cancel print jobs or force the machine to
print the jobs remaining in the receiving buffer. For more information on the operation, refer
to "11 Job Status" in the User Guide.
When the machine is off-line
If a computer instructs a print job while the machine is off-line, the machine does not
receive the data, and a write error dialog box is displayed on the computer.
Environment for Printing via SMB
When using Windows 2000, Windows XP, Windows Server 2003, Windows Server
2008, Windows Server 2008 R2, Windows Vista, or Windows 7 and the [Enabled]
check box is selected for [Unicode Support], you cannot print with the SMB
environment.
When printing via the SMB port on Windows XP, the user name may not be displayed
correctly.
SMB Authentication
When an IP address or a host name is used to designate the authentication server for
SMB authentication, even if the domain name is incorrect, the authentication succeeds
if the correct user name and passcode are entered.
Notes and Restrictions
647
15