Fuji Xerox apeosport-iv C5570 Administrator's Manual page 588

15 Appendix
Setting Item
ESCP switch
Position
adjustment
Escape
sequence
15
586
Item
Number
55 Sets the Text Quality mode to high quality or draft.
(Text quality) [0] (Default)
[1]
Important •Since the default value is selected for the [Text Quality], [Reduced
Note •Changing settings does not change actual printing quality.
•This setting affect the Text Quality selection commands. For more
56 Reduces the size of single-byte alphanumeric characters when printing.
(Reduced Sets whether to reduce their sizes or to print them at a scale of 100%.
characters) [0] (Default)
[1]
58 Sets the length of a page (printable area) to 11 inches or 12 inches.
(Page length) [0] (Default)
[1]
59 Sets whether or not to leave a 1-inch space between pages.
(1-Inch [0] (Default)
perforation skip) [1]
Important •This is effective only when CSF under [Paper Position] is set to [Off].
60 Sets the position to start printing at 8.5 mm or 22 mm below the top edge
(Paper feed of paper.
position) [0] (Default)
[1]
61 Sets the action to be executed when a CR command is received.
(CR feature) [0] (Default)
[1]
15 Adjusts the printing position vertically or horizontally, and changes the
(Vertical positions of the margins.
position [0] (Default)
adjustment) [1-500]
Important •Data outside the printable area is not printed regardless of the
16
(Horizontal
position
adjustment)
62 A normal extended command is specified starting with hexadecimal 1BH
(Escape ESC as the escape sequence identifying the command, followed by ;
sequence) (3BH).
When you cannot use a semicolon or ESC code with the host computer,
you can use a special string instead as an escape sequence. This setting
specifies whether or not to enable the escape sequence replacement
feature. When enabling, specify the escape sequence with item 63.
[0] (Default)
[1]
For more information on extended commands, contact our Customer Support
Center.
63 To control an extended command with a text code, you must specify an
(Escape escape sequence (the first two bytes) of the extended command.
sequence Enter two characters using the keyboard displayed on the screen.
character) [&%] (Default) : 0x21 - 0x7e
Value
: High Quality
: Draft
Characters], [Character Code Table], [Page Length], and [1-inch
Perforation Skip] features, their settings will not be affected when an
extended command is received.
information on the Text Quality selection commands, contact our
Customer Support Center.
: Off
: On
: 11 inches
: 12 inches
: Off
: On
: 8.5 mm
: 22 mm
: Carriage return
: Carriage return and linefeed
: Off
: -250 to +250 mm
adjustment of the print position. In addition, data moved outside the
printable area as a result of adjusting the print position is not printed.
: Disabled
: Enabled