Fuji Xerox apeosport-iv C5570 Administrator's Manual page 468

14 Problem Solving
Error Code
C P F S M O
016-728
016-729
016-731
016-732
016-733
016-735
016-738
016-739
016-740
016-741
016-742
016-743
14
016-744
016-745
016-746
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
466
Category
O [Cause]
[Remedy] Confirm the print data.
O [Cause]
[Remedy] Change the number of colors or resolution for the TIFF file,
O [Cause]
[Remedy] Retry printing.
O [Cause]
[Remedy] Resend the form data.
O O [Cause]
[Remedy] For 1), confirm the e-mail address.
O O [Cause]
[Remedy] Retry printing after waiting for a while.
O [Cause]
[Remedy] Specify a paper size supported for booklet creation, and
O [Cause]
[Remedy] Specify a combination of document size and paper size
O [Cause]
[Remedy] Specify a paper tray supported for booklet creation, and try
O [Cause]
[Remedy] Switch off the machine power, make sure that the touch
O [Cause]
[Remedy] Print using a print driver.
Cause and Remedy
An unsupported tag is included in the TIFF file.
Unable to print because the number of colors or the
resolution of the TIFF file exceeds the allowed range.
and execute the operation again.
Unable to print TIFF data because it was interrupted.
The form specified by emulation has not been registered
at the host side.
Probable causes are as follows:
1) Unable to obtain the IP address (the string after "@" in
the destination e-mail address) when e-mail is sent.
2) DNS server was unable to resolve the Internet address
(the string after "@") by the DNS server when e-mail is
sent.
For 2), confirm the DNS server address.
Attempted to print [Job Template List] while updating the
job template.
Unsupported paper size was specified when specifying
booklet creation with PostScript (optional).
try printing again.
Used an unsupported combination of document size and
paper size when specifying booklet creation with
PostScript (optional).
supported for booklet creation, and try printing again.
Used an unsupported paper tray when specifying booklet
creation with PostScript (optional).
printing again.
An error occurred during the update process of the
machine.
screen is blank, and then switch on the machine power. If
the error still is not resolved, contact our Customer
Support Center.
An unsupported feature is included in the received PDF.