Fuji Xerox apeosport-iv C5570 Administrator's Manual page 455

Category
Error Code
C P F S M O
016-405
016-406
016-450
016-453
016-454
016-455
016-456
016-461
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
Cause and Remedy
O [Cause] An error occurred in the certificate stored in the machine.
[Remedy] Initialize the certificate.
For more information on initializing certificates, refer to "Delete All
Certificates/Initialize Settings" (P.145).
O [Cause] An error occurred in the SSL client certificate.
[Remedy] Take one of the following measures:
1)Store an SSL client certificate in the machine, and set it
as the SSL client certificate.
2)If the SSL client certificate cannot be set, select an
authentication method other than SSL.
O [Cause] The SMB host name already exists.
[Remedy] Change the host name.
Refer to "Host Name" (P.182).
O [Cause] Updating of the IPv6 address and host name for the DNS
server failed.
[Remedy] Check whether the IP address of the DNS server is set
correctly.
O [Cause] Unable to retrieve the IP address from DNS.
[Remedy] Confirm the DNS configuration and IP address retrieve
setting.
Refer to "Protocol Settings" (P.178).
O [Cause] Connection to the SNTP server timed out.
[Remedy] Confirm the network cable connection and the IP address
of the SNTP server are correct.
Refer to "Machine Clock/Timers" (P.132).
O [Cause] Received a message from the SNTP server stating that
the server is not synchronized with the standard time
source.
[Remedy] Confirm the SNTP server settings.
Refer to "Machine Clock/Timers" (P.132).
O [Cause] When [Assurance Level] under the [Transfer Image Log] is
set to [High], you may not be able to create a new job
because of a restriction resulting from the congestion of
un-forwarded image logs.
[Remedy] Confirm the status of the server managing the image logs
and the network status, and eliminate the source
obstructing image log forwarding to the image log server.
Take one of the following measures:
Confirm the forwarding settings, and then forward all un-
forwarded logs.
Change the [Assurance Level] to [Low]. In this case, the
image logs may not be forwarded and may be deleted
successively.
When using the Image Log Kit (Adobe PostScript), and
you switch the machine power off and then on, or when
the machine restarts automatically, switch off the machine
power, make sure that the touch screen is blank, and then
switch on the machine power.
Error Code
14
453